Have Questions? | Habe Fragen?
Always the correct part
We know our products
free shipping for orders above $50
Atomic Metal Conditioner Maximum with 1 Stage Revitalizant Highway Diesel
Atomic Metal Conditioner Maximum with 1 Stage Revitalizant is an innovative 3-component product specially formulated for treating vital engine parts in cars with oil system capacity up to 5 qt. Due to Revitalizant the product reduces friction, rebuilds worn metal in engine parts and creates protective coating against future wear, thus providing tools-free restoration and anti-wear protection. Product application prolongs the life of your engine and allows avoiding expensive repairs in the future. One treatment lasts for 60,000 miles!
- Rebuilds worn engine metal and reverses metal wear
- Increases power and acceleration
- Reduces fuel consumption
- Increases engine cylinders’ compression
- Decreases noise and vibrations
- Restores lost oil pressure up to nominal level
- Protects metal parts from overheating and overloading
- Improves oil lubricating properties and tribological characteristics of engine parts
- Increases engine service life
- Reduce exhaust emissions toxicity (CO2, CO, HC)
- One treatment lasts for 60,000 miles
Make sure the automobile engine is warmed up to normal operating temperature. Turn off the vehicle. Shake the bottle for one minute and ensure it is at room temperature so that contents flow freely. Pour the contents into the engine oil reservoir. Start the car and let the engine idle for five minutes. Then drive as you normally would. It takes 600 to 900 miles to complete the Revitalization cycle, during which changing oil is NOT recommended.
Granules of Revitalizant completely dissolve in motor oil at normal operating temperature.
1 Bottle (225 ml) is enough for engine with an oil capacity of 5 qt. Larger vehicles with higher oil capacities may require more.
- Atomic Metal Conditioner Maximum with 1 Stage Revitalizant works in all gasoline-powered, natural-gas and diesel engines of passenger cars and trucks and 4-stroke motorcycles with oil system up to 5 Quarts
- Can be combined with all types of motor oils, from full synthetic to mineral oils
- It takes 600 to 900 miles to complete the Revitalization cycle, during which changing oil is NOT recommended
- Repeated application of Atomic Metal Conditioner Maximum is recommended after 60,000 miles
- For the highest level of protection for your vehicle’s engine use XADO Atomic Oil or Atomic Metal Conditioner HighWay during each oil change in the future. AMC Highway contains 5.5% (RF5.5) of the active ingredient necessary for 1 complete revitalization cycle
While the claims on this site (through our tests results and testimonials) are accurate, verifiable and typical, individual results may vary depending on proper application, the age, model, and mechanical state of the devise. Some results may very based on user techniques and conditions, such as extreme or rough driving or use.
XADO has been extensively tested on a wide variety of vehicles and mechanical devises without damage to any assembly. Should you realise any damage from proper use of this product, please contact XADO Canada immediately on 1.888.770.9236.
XADO's liability is limited to proper use of the product and excludes improper installation and damage that existed prior to application. Please follow all directions carefully.